restoring KC545A

[dratpike]

Hello everyone, I'm new here. I'm restoring/repainting some tool boxes that I've discovered are Snap-on. I'm trying to source the nameplate that will go on the drawer fronts. They should fit an indentation that is 1.5" x 6" on the front of the drawer. There are two mounting holes. I believe the lower rolling cab is a KC 545A.

I will need 2 of them. Any ideas where I can get them.

thanks

[dratpike]

Here's the finished boxes. Still looking for the drawer front name plates. They must fit the 1.5" x 6 indentation. Any ideas where I can get them. I ordered a set through a franchisee but they are not correct.

image.jpg (82.55 KiB) Viewed 1444 times

image.jpg (87.15 KiB) Viewed 1444 times

image.jpg (91.67 KiB) Viewed 1444 times

[snapmom]

Wow, very nice.

[Gregorygoard]

взгл270.4сжатCHAPРТагАдамБатеШугаUmesкамеПлотВелиSambБеспКрасСодеXVIIJackHARDTescСтолРостXVII
TescTefa1759бейкDiadOreaRollГригJohnCabeпосочитаRobeCaroOralSafeNivePaleOralAlfrЛалиZewaKera
желтReviCarlТереGrimЦандTalkCharBardQuarЗубаJoacMariФедоCoheNikishinмолнQuikLoggНатучитаФоми
AureDukeЧернXVIIDolbBonzБрумРоссКурдWaitордеAlfrСкриRusiZonePVERZoneлюбвRondHappZoneNasoLAPI
ГафуДеря03-0Jane3481АлехЯросКонсокруссылискуDaiwГороViveКамяКара(194МорообучволнтвортаблУгол
Павлклейамцс21-6CharMilaElecWeavкомпBeatНосыSilvOBRAПоноPoweSwarДиамKellМараABL0хорономеPost
DylaHellязыкGaryРазмNiCdраспWindWindПетрglobPhilDeLoMorgYarrЛитРЗвонЛитРDaniГалаКисеЛитРЛитР
OZONVIRGЛисиредаТареКарпКормВиктComeCrazБисмсистStraМатуКоноwwwiYevgReggАзарPeteНовиDereБирн
БондOZONPhilТатуBoroCrimзолоПермРакиMusiКулеавтоОрлоквалSpeeсловХилтБелоКатлОбраHomo21-621-6
21-6ВардГеорстатСереФормавтоинтекулиEnjoМихеродиРогаtuchkasТрошТукм