Page 1 of 1

rail removal for cleaning

Posted: Sun Jun 08, 2014 4:04 pm
by pepflyer
I have what seems to be an early 50's Rolla-Bench, maybe a KRH 300. I have all the drawers out and was wondering if I should remove the drawer rails for soaking and cleaning. How do I remove them? I have been told how to clean them. Pepflyer

Re: rail removal for cleaning

Posted: Sun Jun 08, 2014 7:28 pm
by snapmom

Re: rail removal for cleaning

Posted: Tue Jun 10, 2014 9:04 am
by pepflyer
Back to my June 8th post on my 50's vintage Rolla-Bench cabinet. I have the drawers out and am looking at the removable side drawer guides. I have one that is slightly bent and causes the drawer to be a little tight on movement. I have tried straightening it, but it is very difficult. Can I buy a new rail and if so, how would I identify it to Snap-On? Does anyone have a phone no. for Snap-On parts Dept? Thanks for any suggestions. Pepflyer

Re: rail removal for cleaning

Posted: Tue Jun 10, 2014 9:04 am
by pepflyer
Back to my June 8th post on my 50's vintage Rolla-Bench cabinet. I have the drawers out and am looking at the removable side drawer guides. I have one that is slightly bent and causes the drawer to be a little tight on movement. I have tried straightening it, but it is very difficult. Can I buy a new rail and if so, how would I identify it to Snap-On? Does anyone have a phone no. for Snap-On parts Dept? Thanks for any suggestions. Pepflyer

Re: rail removal for cleaning

Posted: Tue Jun 10, 2014 10:53 am
by snapmom
Sometimes you can correct it using a vise. You can call snap on at 877-777-8455. If they do not have that length, get a longer one and cut it down.
What length is it?

Re: rail removal for cleaning

Posted: Tue Jun 10, 2014 1:56 pm
by pepflyer
The length of the rail I was trying to straighten is 12 5/16" Pepflyer

Re: rail removal for cleaning

Posted: Tue Jun 10, 2014 2:45 pm
by snapmom
If you can't get one from Snappy, I have a used one that size. Holler at me if you want it.

Re: rail removal for cleaning

Posted: Fri May 31, 2024 7:01 am
by Gregorygoard