Page 1 of 1
xdh1214 no date code
Posted: Sat Jan 28, 2012 2:55 pm
by cutiepiereading
I have a XDH1214 3/8 X 7/16 box ends with no date code, any ideas or a range of years in which this was done? It does have the underlined logo and the center of the wrench is round instead of rectangular.
Re: xdh1214 no date code
Posted: Sat Jan 28, 2012 4:32 pm
by toolnut
A picture would help a lot, but it sounds like maybe 50-60's.
Re: xdh1214 no date code
Posted: Sun Jan 29, 2012 2:47 pm
by cutiepiereading
Here is a picture of the wrench, Thank You for your help!
Re: xdh1214 no date code
Posted: Sun Jan 29, 2012 2:50 pm
by cutiepiereading
Another pic
Re: xdh1214 no date code
Posted: Sun Jan 29, 2012 3:28 pm
by Frank Murch
I think much newer - 1980s?
Re: xdh1214 no date code
Posted: Mon Jan 30, 2012 3:16 am
by cutiepiereading
Thank you for your help, Is it common for Snap On tools to not have a date code?
Re: xdh1214 no date code
Posted: Mon Jan 30, 2012 10:17 pm
by J.A.F.E.
In my experience it's not uncommon especially for wrenches.