Hi,
I am restoring a KRA-398 and need a rectangular emblem in poor to very good condition.
It should be about 1.75" x 5" with 3.25" mounting studs.
Thanks
Robert
WTB Snap-On Emblem
Forum rules
The owner of this board assumes no responsibility for the actions of people wishing to buy or sell items, it is merely for provided as an informational service. Use caution as you would with CraigsList.
Please make sure you've read the Rules and Etiquette Page, which spells out the rules and guidelines of this forum.
The owner of this board assumes no responsibility for the actions of people wishing to buy or sell items, it is merely for provided as an informational service. Use caution as you would with CraigsList.
Please make sure you've read the Rules and Etiquette Page, which spells out the rules and guidelines of this forum.
-
KRA-398 Newbie
- Posts: 6
- Joined: Mon Sep 16, 2019 10:29 am
- Your Location: Los Angeles
- Contact:
WTB Snap-On Emblem
- Attachments
-
- Emblem.jpg (48.68 KiB) Viewed 3117 times
-
rustynuts
- Posts: 23
- Joined: Tue Jan 16, 2018 4:31 pm
- Your Location: Ontario
- Contact:
Re: WTB Snap-On Emblem
Hello there,
I have one. It appears new.
You can contact me at: rbagshaw@cogeco.ca
I'm located in Canada.
Robert
I have one. It appears new.
You can contact me at: rbagshaw@cogeco.ca
I'm located in Canada.
Robert
-
KRA-398 Newbie
- Posts: 6
- Joined: Mon Sep 16, 2019 10:29 am
- Your Location: Los Angeles
- Contact:
Who is online
Users browsing this forum: No registered users and 0 guests