Page 1 of 1
Number 3 handle question
Posted: Mon Dec 17, 2012 8:44 pm
by skipskip
did the number 3 Tee handle come without the spinner sleeve?
Or was it only the shorter number 2 that was sleeveless?
thanks
Skip
Re: Number 3 handle question
Posted: Fri Dec 28, 2012 1:23 pm
by snapmom
The early No. 3 did not have the sleeve.
Re: Number 3 handle question
Posted: Sat Jan 05, 2013 8:16 pm
by skipskip
So , in time order
Sleeveless
sleeve with pinched shaft
sleeve with detent ball stops
correct?
thanks
skip
Re: Number 3 handle question
Posted: Sun Jan 06, 2013 11:27 am
by snapmom
There is a three ball stop, a one ball with four pinches, and a one ball with two pinches. The two pinch is very rare.
Re: Number 3 handle question
Posted: Tue Jan 08, 2013 7:50 pm
by skipskip
I have my pinches and balls confused.
one of mine has what look like balls on the shaft rather than pinches
some of the ends where the socket goes have 3 balls , one has only one
here are pics of the three I have
http://www.flickr.com/photos/skipskip/s ... 477308488/
Re: Number 3 handle question
Posted: Wed Jan 09, 2013 4:03 am
by snapmom
Four types of drive ends. two pinched, four pinches, three ball, collar.
Four types of center grips. no grip, pinched, ball (large width grip), ball ( small width grip)
Re: Number 3 handle question
Posted: Wed Jan 09, 2013 12:43 pm
by skipskip
Perfect!!
Thank you
these apply to speeders too?
anything else?
Skip
Re: Number 3 handle question
Posted: Wed Jan 09, 2013 1:49 pm
by snapmom
the socket ends apply to speeders. but the balls go internal with the ones with grips. There were many speeders with no center grips early thru current.