xdh1214 no date code

cutiepiereading · Post by **cutiepiereading** » Sat Jan 28, 2012 2:55 pm

I have a XDH1214 3/8 X 7/16 box ends with no date code, any ideas or a range of years in which this was done? It does have the underlined logo and the center of the wrench is round instead of rectangular.

toolnut · Post by **toolnut** » Sat Jan 28, 2012 4:32 pm

A picture would help a lot, but it sounds like maybe 50-60's.

cutiepiereading · Post by **cutiepiereading** » Sun Jan 29, 2012 2:47 pm

Here is a picture of the wrench, Thank You for your help!

cutiepiereading · Post by **cutiepiereading** » Sun Jan 29, 2012 2:50 pm

Another pic

Post by **Frank Murch** » Sun Jan 29, 2012 3:28 pm

I think much newer - 1980s?

cutiepiereading · Post by **cutiepiereading** » Mon Jan 30, 2012 3:16 am

Thank you for your help, Is it common for Snap On tools to not have a date code?

J.A.F.E. · Post by **J.A.F.E.** » Mon Jan 30, 2012 10:17 pm

In my experience it's not uncommon especially for wrenches.

CollectingSnapOn.com

xdh1214 no date code

xdh1214 no date code

Re: xdh1214 no date code

Re: xdh1214 no date code

Re: xdh1214 no date code

Re: xdh1214 no date code

Re: xdh1214 no date code

Re: xdh1214 no date code

Who is online