Hello everyone, I'm new here. I'm restoring/repainting some tool boxes that I've discovered are Snap-on. I'm trying to source the nameplate that will go on the drawer fronts. They should fit an indentation that is 1.5" x 6" on the front of the drawer. There are two mounting holes. I believe the lower rolling cab is a KC 545A.
I will need 2 of them. Any ideas where I can get them.
thanks
restoring KC545A
Forum rules
Please make sure you've read the Rules and Etiquette Page, which spells out the rules and guidelines of this forum.
Please make sure you've read the Rules and Etiquette Page, which spells out the rules and guidelines of this forum.
-
dratpike
- Posts: 2
- Joined: Wed Sep 10, 2014 4:48 pm
- Your Location: canada
- Contact:
-
dratpike
- Posts: 2
- Joined: Wed Sep 10, 2014 4:48 pm
- Your Location: canada
- Contact:
Re: restoring KC545A
Here's the finished boxes. Still looking for the drawer front name plates. They must fit the 1.5" x 6 indentation. Any ideas where I can get them. I ordered a set through a franchisee but they are not correct.
- image.jpg (82.55 KiB) Viewed 3167 times
- image.jpg (87.15 KiB) Viewed 3167 times
- image.jpg (91.67 KiB) Viewed 3167 times
-
snapmom
- Posts: 1127
- Joined: Sun Oct 17, 2010 2:38 pm
- Contact:
Re: restoring KC545A
Wow, very nice.
Who is online
Users browsing this forum: Ahrefs [Bot] and 126 guests